Electronic Instant Brake
- Operating Frequency and Limitation
- Electronic Instant Brake, could be used for inch movement, a rise in temperature would result from frequent start-stop action of the motor. Please suspend operation temporally if the surface temperature of the motor exceeds 90¡æ.
- Braking Principles
- Electronic brake circuit is design to introduce pulsated direct current rectified by the half wave into motor, to produce directional magnetic field and stop the motor instantly.
- Service Life
- Hence it is electronic brake, there no fiction created between parts, therefore it will extend its lifespan.
- Insulating Resistance: Tested value at 10MΩ and above, measured by DC 500V Hi-Resistance meter between the coil and housing.
-
Hi-Pot Resistance: No damages caused after 1kV at 60Hz was tested for noe minute between the coil and housing.
Selection of External Resistance:
- Output 6W~25W: External resistance 20W/ 20Ω. (Model: DDR20W20ΩJ)
- In frequent braking situation, temperature of external resistance would be very high. Please use external resistance 30W20Ω. (Model: DDR 30W20ΩJ)
- Output 40W~90W: External resistance 50W/ 50Ω. (Model: DDR50W50ΩJ)
- In frequent braking situation, temperature of external resistance would be very high. Please use external resistance 80W50Ω. (Model: DDR 80W50ΩJ)